194
ESPLXD-ET Controller
Connect Cartridge Cables
A
Prior to beginning the installation process, turn the dial on the
front of the LX controller to ETM
TM
/IQ
TM
or ETM
TM
/IQ
TM
/PBC
TM
Settings.
B
Press down on the top-latch of the ET Manager cartridge and
remove it from the back of the controller front panel.
B
C
Plug the ET Manager Receiver/Antenna Cable’s RJ45 connector
(male) into the jack (female) in the back of the ET Manager
Cartridge. Ensure a secure fit when you here it “click” into place.
b
d
CAUTION:
This connector can only go in one way. Ensure that
the ridges on the plug match the slots in the receptacle.
C
D
Connect the green and yellow ground wire to the grounding post
on the left side of the controller backplane.
D
E
Ensure the ETC Cartridge ribbon cable is connected to the knife-
edge connector located at the top-left corner inside the cartridge
bay of the controller front panel.
b
d
CAUTION:
This connector can only go in one way. Ensure that
the RED edge of the ribbon cable is toward the LEFT side of the
opening.
5
ESPLXD-ET user-manual (670504-01) artwork_120716.indb 194
7/16/2012 3:49:03 PM
