137
ESPLXD-ET Controller
Set Up Barcode Scanning Pen
The barcode scanning pen requires initial setup before using.
b
b
NOTE:
The optional barcode scanning pen must be purchased
separately. Rain Bird recommends using a Unitech MS100-2
barcode pen with 9 pin (female) serial connector. Go to www.ute.
com for more details.
A
Locate the Programming Guide that came with the ESPLXD-ET
controller.
1
B
On page 26 of the Programming Guide, under Barcode Scanning
Pen Setup, locate Setup Barcode #1. Scan the barcode lengthwise
as shown. You’ll hear audible beep(s) to confirm that the first scan
was successful.
2
C
Then scan Setup Barcode # 2 and again you’ll hear audible beep(s)
to confirm that the second scan was successful. The barcode
scanning pen is now ready for use.
b
b
NOTE:
If you do not hear audible beep(s) to confirm scan success
then repeat the process until you hear the beeps.
3
ESPLXD-ET user-manual (670504-01) artwork_120716.indb 137
7/16/2012 3:48:45 PM
