Rabe KORMORAN PL V 180, Operating Instructions Manual

Page: 40 / 70

KORMORAN PL V 180 / PL VHA 180
OPERATING INSTRUCTIONS
- 40 -
9901.00.23EN00 - 01/2016
Ploughing on-land
10.2 First pass
7KH¿UVWSDVVGLIIHUVIURPWKHRWKHUVLQWKDWWKHUHLVQRW\HW
DIXUURZWREH¿OOHG
10.2.1 Opening the offset setting jig
1
2
Key
1 Offset
cylinder
2 Position outside the track
ʈ The offset cylinder (item 1) must be in the position for
ploughing "outside the track" (item 2).
ʈ 2SHQWKHRIIVHWVHWWLQJMLJWRLWVPD[LPXPSRVLWLRQ
10.2.2 Adjusting the working depth
The working depth is controlled by the following:
ʈ
Front: The front adjustment wheels and the lifting arm.
ʈ Rear: Implement rear wheel
Adjusting the front adjustment wheel
For the 1st pass, the position of the front adjustment wheel must
be changed. There are two options for this:
ʈ Raise the front wheel by the amount that corresponds to the
required working depth.
ʈ Remove the front adjustment wheel and control the working
depth using the tractor's lifting arm.
Adjusting the wheel height
The wheel's height can be adjusted in the 1st pass. A check and/
RUD¿QDODGMXVWPHQWLVFDUULHGRXWLQWKHVXEVHTXHQWSDVVHV
2
1
Key
1 Adjustment
screw
2 Stop
The screw (item 1) presses against the wheel support's stop
(item 2) when working.
ʈ Increase the working depth:
-
/RRVHQWKHVFUHZLWHPWRH[WHQGWKHOLIWLQJF\OLQGHUVWUDYHO
range and to enable the chassis to be lowered.
ʈ
Decrease the working depth:
-
Tighten the screw (item 1) to limit the lifting cylinder's travel
range and therefore the working depth.
10.2.3 Soil tilling
ʈ
Drive slowly forwards and lower the implement to push the
plough body slowly into the earth.
10.2.4 Adjusting the inclination
The inclination adjustment (side alignment) can only be carried
out if a furrow is present.