KORMORAN PL V 180 / PL VHA 180
MAINTENANCE
- 60 -
9901.00.23EN00 - 01/2016
14 R
ECTIFY
FAULTS
14.1 Replacing the shear bolt on the
mechanical stone protection system
Each plough body is equipped with a shear bolt. If a plough body
becomes blocked, the mechanical stone protection system is
triggered by shearing the shear bolt. The plough body folds in.
Danger:
Risk of injury due to heavy and sharp-edged
components. Gloves should always be worn. Risk of
accident when rectifying the fault. If the implement is
raised, do not work underneath it whilst unsecured.
Secure the implement from lowering.
When releasing the mechanical stone protection system:
ʈ
Stop the tractor immediately.
ʈ
Switch off the tractor and secure it to prevent it rolling away.
ʈ
Secure tractor against being started up (remove ignition key).
14.1.1
Replacing the leg shear bolt
Repair instructions
1
1
2
3
Key
1
Shear bolt x1
2 Washer*
x1
3 Nut
x1
ʈ
*The number of washers may vary. Observe the installation
situation on-site.
ʈ
Always insert the shear bolt from the leg side.
ʈ
Always use original shear bolts.
ʈ
Replace damaged bolts with bolts of the same strength
category.
ʈ
The sheered plough body must point downwards.
ʈ
Only approach the sheered plough body from the rear.
Repair
Warning:
Risk of accident when undoing the pivot bolt.
There is a risk of accident when the plough
body swivels back. Only approach the plough
body from the rear. Use RABE special tools.
1.
ʈ
1. Undo the nuts on the pivot bolt.
2.
3.
ʈ
2. Insert the new shear bolt from the leg side.
ʈ
3. Place the washer on and tighten the fastening nut.
ʈ
Tighten the shear bolt and the pivot bolt to the correct torque.
