Rabe KORMORAN PL V 180, Operating Instructions Manual

Page: 43 / 70

KORMORAN PL V 180 / PL VHA 180
OPERATING INSTRUCTIONS
- 43 -
9901.00.23EN00 - 01/2016
Ploughing in the furrow
The implement can be used inside the track with the tractor.
,QWKLVFRQ¿JXUDWLRQ
ʈ The front adjustment wheels can remain in their positions and
be used in the same way as for ploughing outside the track;
however, this should not be done regularly.
ʈ
The front adjustment wheels can be removed.
In this case, the implement's front is supported by the tractor's
lifting arm and the inclination is controlled using a vertical
adjustment screw.
10.4 First pass
7KH¿UVWSDVVGLIIHUVIURPWKHRWKHUVLQWKDWWKHUHLVQRW\HW
DIXUURZWREH¿OOHG
10.4.1 Opening the offset setting jig
1
2
Key
1 Offset
cylinder
2 Position inside the track
ʈ The offset cylinder (item 1) must be in the position for
ploughing "inside the track" (item 2).
ʈ 2SHQWKHRIIVHWVHWWLQJMLJWRLWVPD[LPXPSRVLWLRQ
10.4.2 Adjust the working depth
The working depth is controlled by:
ʈ Front: Tractor lifting arms.
ʈ Rear: Implement rear wheel
Front height adjustment for the 1st pass
Lower the tractor's lifting arms so that the 1st plough body goes
LQWRWKHHDUWKZLWKRXWFDXVLQJH[FHVVLYHDFFXPXODWLRQV
Adjusting the wheel height
The working depth on the wheel is adjusted using a screw.
2
1
Key
1 Adjustment
screw
2 Stop
The screw (item 1) presses against the wheel support's stop
(item 2) when working.
ʈ Increase the working depth:
-
/RRVHQWKHVFUHZLWHPWRH[WHQGWKHOLIWLQJF\OLQGHUVWUDYHO
range and to enable the chassis to be lowered.
ʈ Decrease the working depth:
-
Tighten the screw (item 1) to limit the lifting cylinder's travel
range and therefore the working depth.
10.4.3 Soil tilling
ʈ
Drive slowly forwards and lower the implement to push the
plough body slowly into the earth.
10.4.4 Adjusting the inclination
The inclination adjustment (side alignment) can only be carried
out if a furrow is present.
10.5 Second pass
Before completing the adjustments, ensure that the mouldboards
are polished and that the earth slides without clumping.
Otherwise, clean the device.
,IHDUWKLVVWXFNUHPRYHWKHWLSVDIWHUWKH¿UVWMREV7KLVFDQ
speed up the smoothing process for the mouldboards.