KORMORAN PL V 180 / PL VHA 180
OPERATING
INSTRUCTIONS
- 36 -
9901.00.23EN00 - 01/2016
2
1
L
A
Key
1 Pivot
bolt
2 Shear
bolt
Before starting work, the subsoiler on the ground side must be
moved from the storage position (S) to the working position (W).
NOTE:
When assembling, observe the position and
alignment of the shear bolt (2).
1
a
A
2
Key
1 Pivot
bolt
2 Shear
bolt
a Connection
points
A Working
position
Adjustment
ʈ
Remove the pivot bolt (1) and the shear bolt (2).
ʈ
Install the subsoiler in the working position (W).
ʈ
Adjust the subsoiler's working depth by setting offsets in the
connection points (a), see chapter "10.14 Adjust subsoiler
(additional equipment)", page 52.
ʈ
Insert the shear bolt (2) and the pivot bolt (1) from the
subsoiler side.
ʈ
Tighten the threaded connection to the correct torque.
Torque - shear bolt
Size
Quality grade 4.6
:LGWKDFURVVÀDWV
(DIN ISO 272)
Nm
Ib/ft
M 16
71
53
24
Torque - fastening screw
Size
Quality grade 8.8
:LGWKDFURVVÀDWV
(DIN ISO 272)
Nm
Ib/ft
M 16
71
53
24
8.9
Combined transport and supporting
wheel
IMPORTANT:
Check the general condition of the wheels.
8.9.1 Tyre
pressure
IMPORTANT:
Check the tyre pressure on a regular basis.
The tyre pressure must not be below the minimum
recommended pressure.
Tyre size
Recommended
operating pressure
bar / MPa
Maximum speed
kph / mph
17.5 / 24
3.5 / 0.35
25 / 15
-
2EVHUYHWKHPDQXIDFWXUHUVUHFRPPHQGDWLRQVSHFL¿FDWLRQV
engraved into the tyre walls).
CAUTION:
$QRYHULQÀDWHGW\UHFDQEXUVW
$QXQGHULQÀDWHGW\UHFDQFRPHORRVHIURPWKH
wheel rim.
8.9.2
Tightening torque for wheel bolts
-
The 1st time after 10 hours or 50 km.
-
Then after a further 10 hours or 50 km.
-
Check the tightening torque of the wheel nuts on a daily basis.
-
Check that all elements are properly tightened at the start of
the season and every 50 hours when using.
IMPORTANT:
Wheels with a lug tread require particular attention
(severe vibration when driving on the road).
