QVI Cobra DRS-300, User Manual

Page: 72 / 100

7. Remove the camera assembly, camera mounting plate, and sensor, and set
down gently.
8. When ready, reinstall the video camera assembly, mounting plate, and
replacement sensor, as described in the next subsection.
Note: The video camera option can only be used with the DRS-300 and
DRS-500 lasers; it cannot be used with the DRS-2000 or DRS-8000 lasers.
This completes the procedure for removing the video camera assembly and
sensor.
Mounting the Video Camera Assembly and Sensor
To mounting the video camera assembly and replacement sensor, follow the
steps below. You will need 2 mm and 3 mm hex key (Allen) wrenches.
1. Place the DRS-300 or DRS-500 laser sensor on a flat surface, label side up.
Then set the camera mounting plate and attached camera on the front of the
sensor. Use the two locator pins on the back of the camera mounting plate
to correctly position it on the sensor.
Note: The video camera option can only be used with the DRS-300 and
DRS-500 lasers; it cannot be used with the DRS-2000 or DRS-8000 lasers.
2. Refer to Figure 4-4 on the following page and perform the following steps:
a. Carefully swing the camera assembly to the right (or left) to reveal the
lower screw hole in the camera mounting plate. Then insert one of the
three partially-threaded screws into the hole and push it through the
camera mounting plate and sensor.
The camera is still attached to the mounting plate via the LED power wires (red
and black). These two wires are fairly delicate. Therefore, keep the camera close
to the mounting plate to avoid damaging either of these two wire
b. With your left (or right) hand, carefully pick up the camera mounting
plate and laser sensor, and then position and hold them on the sensor
mounting pad. Use the two positioning pins on the sensor mounting
pad to align the sensor and camera mounting plate over the mounting
holes in the mounting pad. When positioning the components, make
sure that the camera mounting plate remains aligned on the sensor.
c. With your free hand, use a 3 mm hex key (Allen) wrench to tighten the
partially-threaded screw you inserted into the lower mounting hole
(Step 2a) and secure the camera mounting plate and sensor to the
sensor mounting pad.
Swapping Sensors 4-5
Swapping
Sensors