7.
If you purchased the Factory-supplied Computer option, unpack and set up
the computer and components at this time.
8.
Connect a parallel cable from the
PARALLEL PORT
on the Cobra back
panel (see Figure 2-14) to the parallel port on the associated computer.
9.
Plug the female end of the supplied Cobra power cord into the power cord
receptacle on the back panel of Cobra (see Figure 2-14) and connect the
male end into a properly configured outlet.
10. If you did
not
purchase the Factory-supplied Computer option, install the
Scan-X software onto the associated computer (described later in this
section). It is pre-installed on computers purchased from the factory.
Note:
Before using your Cobra, you may need to focus and align the camera, as
described in Appendix B.
This completes the procedure for mounting the video camera and LCD screen
assemblies on your Cobra 2D.
Installation and Setup
2-13
Installation
and
Setup
Figure 2-14. Cobra with Video Camera Option, Fully Assembled
Summary of Contents for Cobra DRS-300
