QVI Cobra DRS-300, User Manual

Page: 28 / 100

3. Use a 3 mm hex key (Allen) wrench to remove the two screws shown in
Figure 2-5, which partially frees the camera from its mounting plate. Set the
screws aside; you will need them later.
The camera is still attached to the mounting plate via the LED power wires (red
and black). These two wires are very delicate. Therefore, keep the camera as
close as possible to the mounting plate to avoid damaging either wire.
4. Place the DRS-300 or DRS-500 laser sensor on a flat surface, label side up.
Then set the camera mounting plate and attached camera on the front of the
sensor. Use the two locator pins on the back of the camera mounting plate
to correctly position it on the sensor.
Note: The video camera option can only be used with the DRS-300 and
DRS-500 lasers; it cannot be used with the DRS-2000 or DRS-8000 lasers.
Installation and Setup 2-7
Installation
and
Setup
Figure 2-5. Freeing the Camera from the Mounting Plate