
18. In the Output window, select
Length
in the second measurement
drop-down box.
19. Click and drag the primary cursor boundaries to the start of the first column
and the end of the last column in the profile, as shown below.
-
The position of the reference cursor does not have an effect on this
measurement.
-
The length of the Lincoln Memorial is displayed in the Output window,
next to
Length
, and should be approximately 12.0 mm.
20. In the Output window, check the box next to
Length
.
-
The software automatically lists the length results in the Report View
window.
21. Click on the
Save
icon or select
Save
in the
File
menu.
-
The Save File dialog box is displayed.
22. Select
.sc6
in the
Save as Type
list.
23. Select the folder where you want to save the file.
24. Enter a filename (for example, Penny_scan).
25. Click on
Save
.
26. Click on the
Report View
tab to display the Report View window.
-
The results of the height and length measurements are listed.
-
If a printer is connected to the system, click on the
button to
output the measurement results to the printer
27. If you performed a 3D scan, click on the
Raster
tab to display the Raster
View window.
-
The Raster View is composed of multiple profiles, which provide a
top-view, three-dimensional map of the part or feature.
You have successfully completed this tutorial.
Getting Started
3-11
Getting
Started
Summary of Contents for Cobra DRS-300
