QVI Cobra DRS-300, User Manual

Page: 51 / 100

Enabling Scan-X 3D Mode
This subsection only applies to users who are using Scan-X on a Cobra 3D
system that was purchased without the Factory-supplied Computer option. If
your Cobra 3D system was purchased with the Factory-supplied Computer
option, you can skip this section because Scan-X 3D mode was enabled at the
factory.
To enable Scan-X 3D mode, follow the steps below.
1. Open the SCANX.INI file located in the following default directory:
C:\Program Files\Scan-X\Config
2. Enter a 2 in the Stages field, see below.
3. Save the file by selecting File / Save before exiting.
2-30 Installation and Setup