QVI Cobra DRS-300, User Manual

Page: 76 / 100

4. Remove the sensor from the sensor mounting pad, by pulling it away from
the Cobra.
5. When you are ready, install the replacement sensor, as described in the next
procedure.
This completes the procedure for removing the laser sensor.
Mounting a Sensor
To mount a sensor onto your Cobra system, follow the steps below. You will
need a 3 mm hex key (Allen) wrench.
1. Power down your Cobra system.
2. Mount the laser sensor onto the sensor mounting pad. Use the two
positioning pins to align the sensor correctly over the mounting holes, see
Figure 4-8 below.
Note: Mount the sensor so that the laser sensor connector is on the left side of
the sensor as shown in Figure 4-8.
Swapping Sensors 4-9
Swapping
Sensors
Figure 4-8. Mounting a Sensor