QVI Cobra DRS-300, User Manual

Page: 33 / 100

4. Locate the Video Signal cable. Connect the female end to the top of the
camera (see Figure 2-13, Part A) and connect the male end to the back of
the LCD screen (see Figure 2-13, Part B).
Never connect or disconnect the laser sensor cable from the top of the sensor
while power is applied to Cobra. Doing so can seriously damage the sensor.
5. Connect the laser sensor cable to the top of the sensor as shown in
Figure 2-14 on the following page.
6. Use approximately eight cable tie-wraps to route and secure the cables to
Cobra as shown in Figure 2-14 on the following page.
2-12 Installation and Setup
Figure 2-13. Connecting the Video Signal Cable