QubicaAMF Edge String, Owner'S Manual

Page: 195 / 210

Owner’s Manual
400-051-202-01 Rev. B
Page E-15
Precautions: LOTO, Lane Barriers, Slip Hazard, Trip Hazard
Tools:
•
7
/
16
” Wrench
Location: Front of Machine
Est. Time: 15 min
Procedure:
1. Before LOTO, press PINS UP .
2. Implement LOTO and deploy lane barriers.
3. Slide clear tubing off actuation and hard-stop string clamps.
4. Loosen nuts on clamps.
5. Adjust length of actuation string by sliding string through clamp. Shield panel must be
horizontal with drawbar fully rearward (toward reel arms). See Figure E-13. Tighten
rope clamp after adjustment.
6. Detach (unclip) actuation string from shield carabiner.
7. Adjust length of hard-stop string by sliding string through clamp. Shield panel must be
vertical with hard-stop string tight. See Figure E-14. Tighten rope clamp after
adjustment.
a. Check if shield panel can swing past vertical. If so, shorten hard-stop string to
avoid damage to pitlight.
8. Attach (clip) actuation string to shield carabiner.
9. Remove LOTO and lane barriers. Return machine to service.
Figure E-12, “Double Figure 8” Knot