QubicaAMF Edge String, Owner'S Manual

Page: 81 / 210

Owner’s Manual
400-051-202-01 Rev. B
Page 4-7
DRV CAL ERR Drawbar failed to reach end of travel during first pinspotting cycle
following machine startup or string adjustment procedure. Press
WORK then PLAY to clear error. Check that strings are not too
tight and loosen strings if needed. Restart power to machine
control box, press
FULL SET , then press PLAY . Check that
drawbar drive system is not jammed (drive chains too tight,
internal string tangle, worn components, etc.). Check all electrical
connections between control box and motor. Replace control box
and/or motor if needed.
E-STOP Machine is shut down in emergency stop condition. E-STOP
pushbutton has been pressed. Follow standard procedure to reset
E-Stop. Check that E-Stop jumper is securely connected in rear of
system controller. Replace system controller if needed.
KEYPAD ERR Stuck button on system controller keypad. Replace system
controller.
LIFT ERR 1 Chain lift control box does not recognize chain lift motor. Press
WORK then PLAY to clear error. Restart power to control box,
press FULL SET , then press PLAY . Check all electrical
connections between control box and motor. Replace control box
and/or motor if needed.
LIFT ERR 2 Chain lift control box over-voltage condition. Press WORK then
PLAY to clear error. Restart power to control box, press FULL
SET , then press PLAY . Check all electrical connections between
control box and chain lift motor. Replace control box and/or
motor if needed.
LIFT ERR 3 Chain lift control box over-temperature condition. Press WORK
then PLAY to clear error. Restart power to control box, press
FULL SET , then press PLAY . Check that chain lift drive system
is not jammed (drive chain too tight, lifter assembly caught, worn
components, etc.). Check all electrical connections between
control box and motor. Replace control box and/or motor if
needed.
LIFT ERR 4 Chain lift control box internal voltage measurement error. Press
WORK then PLAY to clear error. Restart power to control box,
press FULL SET , then press PLAY . Check all electrical
connections between control box and motor. Replace control box
and/or system controller if needed.
LIFT ERR 6 Chain lift did not cycle after 30s of being instructed to operate.
Press
WORK then PLAY to clear error. Restart power to chain
lift control box (chain lift should re-calibrate). Check that chain
lift drive system is not jammed (drive chain too tight, lifter
assembly caught, worn components, etc.). Check all electrical
connections between control box and motor. Replace control box
and/or motor if needed.
LIFT ERR 7 Invalid chain lift configuration set on the configuration jumpers.