QubicaAMF Edge String, Owner'S Manual

Page: 88 / 210

Owner’s Manual
400-051-202-01 Rev. B
Page 4-14
4.5.5. Machine Does Not Cycle When Ball is Thrown
Cause 1: System controller Chassis Mode setting not set correctly for given lane
Solution: Set system controller Chassis Mode setting to BOWL (see Page
2-21).
Cause 2: System controller error code (machine has shut down)
Solution: See Table 4-1 for complete list of system controller error codes
and troubleshooting tips.
Cause 3: Ball detector malfunction/out of alignment
Solution: Check ball detector/reflector alignment. Check for any damage
or dust on reflector and sensor. Check all electrical connections
between ball detector and system controller. In the
Text or
Graphics sub-menus of the system controller Diagnostics menu,
verify that Ball Detector status alternates between BALL and
NO BALL while passing object through detector beam (see
Pages 2-24, 2-25). Restart power to system controller. Replace
components as needed.
4.5.6. Machine Cycles When Ball is Not Thrown
Cause 1: Ball detector malfunction/out of alignment or is dirty
Solution: Check ball detector/reflector alignment. Check for any damage
or dust on reflector and sensor. Check all electrical connections
between ball detector and system controller. In the
Text or
Graphics sub-menus of the system controller Diagnostics menu,
verify that Ball Detector status alternates between BALL and
NO BALL while passing object through detector beam (see
Pages 2-24, 2-25). Restart power to system controller. Replace
components as needed.
Cause 2: Shield panel interrupting ball detector beam
Solution: Reposition ball detector/reflector so that shield panel does not
interrupt beam during normal operation.
4.5.7. Pins Do Not Settle on Pindeck at Same Time
Cause 1: Strings are too tight/loose.
Solution: Perform a string adjustment (see Page 3-5).
4.5.8. Pins Fell Over When Being Spotted
Cause 1: Strings are too loose.
Solution: Perform a string adjustment (see Page 3-5).
Cause 2: Bottom of pin is damaged.
Solution: Replace pin (see Page 3-9).