QubicaAMF Edge String, Owner'S Manual

Page: 89 / 210

Owner’s Manual
400-051-202-01 Rev. B
Page 4-15
Cause 3: Foreign object on playing surface.
Solution: Clean pindeck (see Page 3-4).
4.5.9.
System Controller Keypad Non-Responsive
Cause 1: Faulty keypad/system controller
Solution: Using the Keypad Test tool in the system controller Diagnostics
menu (see Page 2-25) test any non-functioning pushbuttons.
Restart power to system controller. Replace system controller if
needed.
4.5.10. Machine Not Scoring Correctly
Cause 1: System controller Scoring System setting not set correctly
Solution: If operating with QubicaAMF scoring, set system controller
Scoring System setting to SCORING. If operating with non-
QubicaAMF scoring, set to BASIC or STANDALONE. See
Page 2-21.
Cause 2: System controller Game setting not set correctly.
Solution: Set system controller Game setting to 10 PINS (see Page 2-21).
Cause 3: System controller Inhibit Pin Errors setting not set correctly
Solution: Set system controller Inhibit Pin Errors setting to OFF see
Page 2-22). System controller will now output pin encoder and
pin brake errors (if applicable), which can then be addressed.
Cause 4: System controller Pin Data Delay setting not set correctly
Solution: Factory default setting is 3.0 seconds. (see Page 2-21).
Increasing value will provide more time for pin action to settle
before frame is scored but will delay start of next machine
cycle.
Cause 5: System controller Pin Detect Count setting not set correctly
Solution: Recommended setting is 12 (see Page 2-21). Increasing value
will allow for greater pin shift (off-spotting) during play but
may not score a pin correctly if value is set too high.
4.5.11. Foul Detector Not Functioning Correctly
Cause 1: Foul detector malfunction
Solution: Check foul detector/reflector alignment. Check for any damage
or dust on reflector and sensor. Check all electrical connections
between foul detector and system controller. In the
Text sub-
menu of the system controller Diagnostics menu, verify that
Foul Detector status alternates between FOUL and NO FOUL
while passing object through detector beam (see Page 2-24, 2-