QubicaAMF Edge String, Owner'S Manual

Page: 68 / 210

Owner’s Manual
400-051-202-01 Rev. B
Page 3-8
12. Remove LOTO and lane barriers. Return machine to service.
Figure 3-3, String Routing Figure 3-4, “Figure 8” Knot
3.3.3. Replace Pin and/or String Sleeve
Precautions: LOTO, Pin Hook, Lane Barriers
Tools:
•
#2 Phillips Screwdriver
•
Pin Hook
•
String Sleeve Tool (051-200-700)
Location: Operator Access Area (behind machine)
Est. Time: 5 min for 1 Pin OR 30 min for All
Note:
•
A string adjustment may be needed after this procedure.
Procedure:
1. Implement LOTO and deploy lane barriers.
2. Open machine rear cover.
3. Retrieve pin with pin hook and place on top of pit hinged top cover.
4. Insert screwdriver into small hole on side of pin. Push string knot out through large hole
on side of pin.
5. Untie knot and remove pin from string. Remove string sleeve if it needs to be replaced.
6. Install new sleeve (if applicable) on string using string sleeve tool. See Figure 3-5.
7. Pass string through hole on top of pin and out through large hole on side of pin. See
Figure 3-3.
8.
Tie a “Figure 8” knot at end of string and pull knot into pin. See Figure 3-4.
9. Return pin to pit.
10. Close machine rear cover.
11. Remove LOTO and lane barriers. Return machine to service.