QubicaAMF Edge String, Owner'S Manual

Page: 55 / 210

Owner’s Manual
400-051-202-01 Rev. B Page 2-23
MCU Menu
The system controller MCU menu contains sub-menus for Settings , Functions , Ball
Counters , and Frame Counters . Options within these sub-menus can be used for daily
machine operation, troubleshooting, and preventive maintenance. Press MENU once to
access the MCU menu. Then, scroll down to the desired sub-menu and press OK to
access its available options. Press BACK to return to the previous screen or continue
pressing BACK to return to the home screen.
Settings Sub-Menu
The Settings sub-menu includes several user-configurable settings which the operator can
set based on operational preferences, bowling center layout, and equipment
configuration. All available settings are described below.
Table 2-3, Settings Sub-Menu
Parameter Possible Settings Additional Information
Low Lane ID 1, 2, 3, 4, 5 …127 Set to lowest lane number of the pair. For single
lanes, set to that lane number.
Chassis Mode BOWL, STANDBY See page 2-20 for definitions of machine modes.
MECHANIC mode is automatically set by
pressing any of the lane-specific machine control
pushbuttons.
Auto Ball Return Shutoff ON, OFF Recommended setting is ON.
Ball Return Select QAMF, OTHER Set for brand of front ball return installed.
Foul Type Xli, XL Set to Xli for use with Radaray Xli or Radaray
Plus. Set to XL for use with Radaray XL.
Foul Detector ON, WARNING, OFF Select ON for warning buzzer and score penalty.
Select WARNING for buzzer only (no score
penalty). Select OFF for no warning buzzer or
score penalty.
Game 10PINS, DUCKPIN,
HIGHWAY66 Set to 10PINS for Tenpin use.
Mask Lights AS BALL NUMBER, AS
BOWL/NO BOWL Set to AS BALL NUMBER for 10-Pin use.
Pin Data Delay 2.0, 2.3, 2.6, 3.0, 3.3, 3.6, 4.0,
4.3, 4.6, 5.5 Time (in seconds) after ball is detected before pin
fall data is collected. Recommended setting is 3.0.
Increasing value will score delayed pin falls but
will delay start of next machine cycle.
Pin Detect Count
4, 5, 6…15
Relative string movement required to register a
fallen pin. Recommended setting is 12.
Pin Park State UP, DOWN, PINS/SHEILD
UP Sets pin parking position when machine is turned
OFF.
Pit Light WHITE, COLOR Select WHITE for white light. Select COLOR for
light color.
Scoring System SCORING, STANDALONE,
BASIC Select SCORING for use with QubicaAMF
scoring system. Select STANDALONE for no
scoring. Select BASIC for use with other
manufacturer’s scoring system.
Tenth Frame Switch Full, PARTIAL, OFF Determines machine response when tenth frame
switch (if installed on front ball return) is pressed.
Select Full for full pin set, PARTIAL for partial
pin set, or OFF for no response.