Protecting Your Adventure Lifestyle
==============================================================================================
QUALITY
●
INTEGRITY
●
INNOVATION
●
SERVICE
Warrior Products, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone: (888) 220-6861
Fax: (503) 692-0364
3860 FJ Cruiser Platform Rack
Kit Contents:
Item
Qty
Item
Qty
Main Platform
1
M8 SS Button head cap screw
12
Front Mount (SMALL) - LEFT
1
5/16” Lockwasher
12
Front Mount (SMALL) - RIGHT
1
5/16” Washer (SMALL)
12
Rear Mount (LARGE) - LEFT
1
3/8” x 1”
Hex Bolt
12
Rear Mount (LARGE) - RIGHT
1
3/8” Washer (LARGE)
24
3/8” Nyloc Nut
12
Installation Instructions:
1.
Locate the 6 mounting points on the roof of the
vehicle by removing the existing roof rack, or by
removing the covers in the roof trim.
2.
Remove the 2 bolts and the bracket from each
mounting point, leaving only the channel with 2
plastic sleeves remaining (Figure 1). Loosen BOTH
bolts before you remove either bolt. Do not
remove a bolt without first loosening the bolt next
to it. Failing to follow this procedure may cause
damage to the brackets inside the roof.
3.
On each side of the vehicle, attach the small
mount to the front mounting point, and the large
mount to the rear two mounting points on each
side of the roof with the upper tabs of the bracket
facing inboard, toward the center of the vehicle
roof (as shown in Figure 2). Place the mounting
bracket into the channel so that the plastic
sleeves are positioned in the holes of the mount.
Attach the mounts with the supplied M8 Button
Head cap screws, lock washers, and small
washers. Fully tighten all twelve mounting
screws.
(Optional: You may want to apply some silicon or
other gasket material around the plastic sleeves in
the roof to ensure a water proof installation.)
Figure 1
Figure 2
