![background image](http://html.mh-extra.com/html/quantum/superloader-3a-series/superloader-3a-series_user-manual_770658026.webp)
Chapter 2 Operating the Autoloader
Configuring the Autoloader
Quantum SuperLoader 3A Series User’s Guide
12
2
From the
Configuration
menu, scroll to
Ethernet
, and then press
Enter
.
3
From the
Ethernet
submenu, scroll to
Set SNMP Server
, and then press
Enter
. The cursor automatically displays at the first digit.
4
At each position of the SNMP server address, use the up and down
arrows to change the value of each digit. Press
Enter
to advance the
cursor to the next digit.
When you have advanced through all of the digits of the SNMP
server address, the autoloader displays
Enter to save
.
5
Press
Enter
.
New SNMP Server xxx.xxx.xxx.xxx
displays on the LCD.
You do not need to reboot the autoloader.
6
Press
Escape
or
Enter
to return to the
Ethernet
submenu.
Setting the Time
2
The system time is displayed by On-board Remote Management and it is
used internally when logging events and errors. The system time is either
regular time or power-on time. Regular time is Month/Date/Year Time,
such as
Nov/21/2004 19:28
. Power-on time is Power On Cycles/Power On
Hours. For example,
POC: 00121, POH: 00002:07:45
where POC is the
number of times the system has booted since it was manufactured, and
POH is the number of hours, minutes, and seconds since the last system
boot. If regular time is known, it will be used, otherwise power-on time is
used.
The SuperLoader 3A Series must be reset after each power up. The time
can be reset automatically if a time server is configured.
Setting the Time Server
2
If you locate a time server that is compatible with Simple Network Time
Protocol (SNTP), you can connect the autoloader to a server that will
supply the correct date and time. The autoloader uses this information to
time stamp information in its memory.
To set a time server address:
1
From the main menu, scroll to
Configuration
, and then press
Enter
.
2
From the
Configuration
menu, scroll to
Ethernet
, and then press
Enter
.
Note:
If you make a mistake, press
Escape
to backspace to the
digit you want to change.