Chapter 3 On-board Remote Management
Configurations Page
Quantum SuperLoader 3A Series User’s Guide
36
From any page, click the
Configuration
heading. The
Configuration
screen
displays. Under the
Compression
heading, the current compression
setting is displayed as
Compression Enabled
or
Compression Disabled
.
Barcode Reader
3
The bar code reader is enclosed within the body of the autoloader. The
information from each label is stored in memory and available through
SCSI and On-board Remote Management to the computer's operating
system or backup application upon request.
The barcode reader can be
Enabled
or
Disabled
.
The
SCSI Barcode Length
entry sets the number of characters of the
barcode returned by
SCSI Read Element Data
. Setting the barcode length
to zero disables truncation of the barcode and the full barcode is returned
in the
SCSI Read Element Data
.
If utilizing the bar code reader, you must apply or slide the bar code
labels into the appropriate slot on the front of each cartridge. The labels
must conform to ANSI/AIM BC1 -1995 Uniform Symbology Specification
Code 39. A set of bar code labels is initially included with the autoloader.
Refer to
www.quantum.com
for information on obtaining additional bar
code labels.
Cleaning Tape
3
To enable or disable the
Auto Clean
function, you must also designate a
full slot for the cleaning tape cartridge. If a slot has not been designated,
the box displays
None
.
To designate the cleaning tape slot:
1
Load a cleaning tape into an empty slot using the
Commands
page.
2
Enable or disable
Auto Clean
by selecting the check box.
Note:
If
Auto Clean
is disabled, the cleaning tape will
automatically be ejected via the mailslot. Cleaning is
managed by the backup package you have installed
instead.