Qlogic SANbox 1400 Series, User Manual

Page: 104 / 278

4 – Managing Switches
Resetting a Switch
4-16 59226-00 B
S
Common administrative operations that change the fabric include:
„
Zoning modifications
„
Adding, moving or removing devices attached to the switch fabric. This
includes powering up or powering down attached devices.
„
Adding, moving or removing ISLs or other connections.
Management Interfaces:
After an NDCLA operation is complete, management connections must be
re-initiated:
„
SANsurfer Switch Manager sessions will re-connect automatically
„
Telnet sessions must be restarted manually.
Applicable Code Versions:
„
Future switch code releases will be upgraded non-disruptively unless
specifically indicated in its associated release notes
„
An NDCLA operation to previous switch code releases is not supported.
To reset a switch using SANsurfer Switch Manager, do the following:
1. Select the switch to be reset and open the faceplate display.
2. Open the Switch menu and select the Reset Switch pull-down menu:
„
Select Hot Reset to perform a hot reset.
„
Select Reset to perform a standard reset.
„
Select Hard Reset to perform a hard reset.
Table 4-3. Switch Resets
Type Description
Hot Reset Resets a switch without a power-on self test. This reset activates
the pending firmware, but does not disrupt switch traffic. If errors
are detected on a port during a hot reset, the port is reset automat-
ically.
Reset without
POST Resets a switch without a power-on self test. This reset activates
the pending firmware and it is disruptive to switch traffic.
Hard Reset Resets a switch with a power-on self test. This reset activates the
pending firmware and it is disruptive to switch traffic.