Qlogic SANbox 1400 Series, User Manual

Page: 197 / 278

A – Command Line Interface
Set Config Command
59226-00 B A-43
A
switch
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
Table A-10 describes the Set Config Switch
parameters.
IOStreamGuard I/O Stream Guard. Enables or disables the suppression
of RSCN messages. IOStreamGuard can have the fol-
lowing values:
„
Enable – Suppresses the reception of RSCN mes-
sages from other ports for which IOStreamGuard is
enabled.
„
Disable – Allows free transmission and reception of
RSCN messages.
„
Auto – Suppresses the reception of RSCN mes-
sages under the following conditions: 1) The port is
connected to an initiator device with a QLogic HBA,
2) The DeviceScanEnable parameter is enabled.
Auto is the default.
PDISCPingEnable Enables (True) or disables (False) the transmission of
ping messages from the switch to all devices on a loop
port. The default is True.
Table A-10. Set Config Switch Parameters
Parameter Description
AdminState Switch administrative state: online, offline, or diagnos-
tics. The default is Online.
BroadcastEnabled Broadcast. Enables (True) or disables (False) forward-
ing of broadcast frames. The default is True.
InbandEnabled Inband management. Enables (True) or disables
(False) the ability to manage the switch over an ISL.
The default is True.
FDMIEnabled Fabric Device Monitoring Interface. Enables (True) or
disables (False) the monitoring of target and initiator
device information.
Table A-9. Set Config Port Parameters (Continued)
Parameter Description