Qlogic SANbox 1400 Series, User Manual

Page: 196 / 278

A – Command Line Interface
Set Config Command
A-42 59226-00 B
S
AutoPerfTuning Automatic performance tuning for FL_Ports only. The
default is True.
„
If AutoPerfTuning is enabled (True) and the port is
an FL_Port, MFSEnable is automatically enabled.
LCFEnable and VIEnable are overridden to False.
„
If AutoPerfTuning is disabled (False), MFSEnable,
LCFEnable, and VIEnable retain their original val-
ues.
LCFEnable Link control frame preference routing. This parameter
appears only if AutoPerfTuning is False. Enables (True)
or disables (False) preferred routing of frames with
R_CTL = 1100 (Class 2 responses). The default is False.
Enabling LCFEnable will disable MFSEnable.
MFSEnable Multi-Frame Sequence bundling. This parameter
appears only if AutoPerfTuning is False. Prevents (True)
or allows (False) the interleaving of frames in a
sequence. The default is False. Enabling MFSEnable
disables LCFEnable and VIEnable.
VIEnable Virtual Interface (VI) preference routing. This parameter
appears only if AutoPerfTuning is False. Enables (True)
or disables (False) VI preference routing. The default is
False. Enabling VIEnable will disable MFSEnable.
MSEnable Management server enable. Enables (True) or disables
(False) management server on this port. The default is
True.
NoClose Loop circuit closure prevention. Enables (True) or dis-
ables (False) the loop’s ability to remain in the open state
indefinitely. True reduces the amount of arbitration on a
loop when there is only one device on the loop. The
default is False.
Table A-9. Set Config Port Parameters (Continued)
Parameter Description