Qlogic SANbox 1400 Series, User Manual

Page: 195 / 278

A – Command Line Interface
Set Config Command
59226-00 B A-41
A
LinkSpeed Transmission speed: 1-Gbps, 2-Gbps, 4-Gbps, or Auto.
The default is Auto.
PortType Port type: GL, G, F, FL, Donor. The default is GL.
SymbolicPortName Descriptive name for the port. The name can be up to 32
characters excluding #, semicolon (;), and comma (,).
The default is Port n where n is the port number.
ALFairness Arbitration loop fairness. Enables (True) or disables
(False) the switch’s priority to arbitrate on the loop. The
default is False.
DeviceScanEnabled Enables (True) or disables (False) the scanning of the
connected device for FC-4 descriptor information during
login. The default is True.
ForceOfflineRSCN Enables (False) or disables (True) the immediate trans-
mission of RSCN messages when communication
between a port and a device is interrupted. If enabled,
the RSCN message is delayed for 200 ms for locally
attached devices and 400 ms for devices connected
through other switches. The default is False. This param-
eter is ignored if IOStreamGuard is enabled.
ARB_FF Send ARB_FF (True) instead of IDLEs (False) on the
loop. The default is False.
InteropCredit Interoperability credit. The number of buffer-to-buffer
credits per port. 0 means the default (8) is unchanged.
Changing interoperability credits is necessary only for
E_Ports that are connected to non-FC-SW-2-compliant
switches. Contact your authorized maintenance provider
for assistance in using this feature.
ExtCredit Extended credits. The number of port buffer credits that
this port can acquire from donor ports. The default is 0.
FANEnable Fabric address notification. Enables (True) or disables
(False) the communication of the FL_Port address, port
name, and node name to the logged-in NL_Port. The
default is True.
Table A-9. Set Config Port Parameters (Continued)
Parameter Description