Qlogic SANbox 1400 Series, User Manual

Page: 212 / 278

A – Command Line Interface
Set Setup Command
A-58 59226-00 B
S
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table A-14 describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
ReadCommunity Read community password that authorizes an SNMP agent to
read information from the switch. This is a write-only field. The
value on the switch and the SNMP management server must
be the same. The read community password can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is “public”.
WriteCommunity Write community password that authorizes an SNMP agent to
write information to the switch. This is a write-only field. The
value on the switch and the SNMP management server must
be the same. The write community password can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is “private”.
TrapCommunity Trap community password that authorizes an SNMP agent to
receive traps. This is a write-only field. The value on the switch
and the SNMP management server must be the same. The
trap community password can be up to 32 characters excluding
#, semicolon (;), and comma (,). The default is “public”.
AuthFailureTrap Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
ProxyEnabled Enables (True) or disables (False) SNMP communication with
other switches in the fabric. The default is True.
NOTE: Changing the IP address will terminate all Ethernet management
sessions.
Table A-14. System Configuration Settings
Entry Description
Eth0NetworkDiscovery Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
Eth0NetworkAddress Ethernet Internet Protocol (IP) address. The default is
10.0.0.1.
Table A-13. SNMP Configuration Settings (Continued)
Entry Description