49
Stop
Click
Stop
to interrupt measurement. Current operating conditions do no longer appear.
Logging
With the
Logging
function you can record the values which have been calculated by the sensor during
operation display mode in a file. The log file can be defined in the general software settings (see 18.8).
Don’t clear display
The
Don’t clear display
function allows you to retain the detected values after the operation display
has been stopped. When activating operation display again, the graphical representation will continue
from the last measured value.
Status message
When occurring, errors are displayed in this box. The message will be shown for a time according to
the setting in
“polling interval” (see 18.1).
Signal quality
This box allows you to check the reflectivity of the object to be measured. To do this, operation display
needs to be stopped. Values between 0 (no measurement possible) up to 8900 (very good signal
quality) are shown. When operation display has been activated, the box is blank.
18.6 Receive parameters from device / Transmit parameters to device
By clicking
Receive parameters
, settings running in the equipment will be transferred
into the software.
Note:
Changes which have been made in the software settings but not transferred into
the equipment will be overwritten.
By clicking
Transmit
Parameters
, settings being displayed in the software will be
transferred into the sensor.
Note:
All settings running in the equipment will be overwritten.
You have the opportunity to store settings before any transfer (see 18.7).
