Installation and Operation Manual
Page 59 of 156
[PVI-XXX.0-YY(-TL) - Rev:1.0]
The mechanical parts that will complete the
base are packaged separately and placed on
the top of the inverter (Figure 9-4). These
should be mounted after the device and
connection
cables
were
placed
in
permanently.
Figure 9-4: Closure mechanisms of the front
and rear base
9.2.3
Handling of the PVI-XXX.0
(-TL)
After opening the crate, the inverter may be
withdrawn.
NOTICE
The
withdrawal
operation
from
the
packaging and positioning of the device
must
be
performed
using
specific
equipment and methods described in Figure
9-6.
The following images of Figure 9-5, describe
instead what must be done to avoid causing
damage to the equipment.
It must be kept in mind that the weight of
the inverter is not evenly distributed and
therefore particular care must be taken
when it is lifted.
NOTICE
The inverter may be moved by forklift truck.
Since much of the weight is distributed in
the upper part, it is absolutely essential to
pay maximum attention when moving.
It is important to fork up the inverter in a
way
which
guarantees
the
widest
supporting base possible and which does
not facilitate the risk of tipping up.
