Planmeca Compact i Classic v2, User Manual

Page: 95 / 190

When the scaler is the active instrument, the scaler mode can be changed
by pressing Chip blow.
NOTE
The foot control can be configured so that you push the left-side knob down
to change the scaler mode. Contact your Planmeca dealer.
NOTE
Check the scaler mode symbol on the control panel to verify that pushing the
left-side knob down activates the correct function.
20.5.6 Instrument light
The instrument light is either on or off when you pick up the instrument from
the instrument console.
Whether the light is on or off, as well as its intensity, can be defined in the
programming mode, see section "Instrument light" on page 100.
20.6 Planmeca Lumion Plus polymerisation light
CAUTION
The polymerisation light generates optical radiation and proper safety
measures should be taken when using the instrument. For detailed
information, please refer to OEM documentation.
CAUTION
Do not use the polymerisation light on patients with cardiac pacemakers.
The polymerisation light can cause disturbance on the pacemaker’s function.
NOTE
When the polymerisation light is taken from the holder in the instrument
console and returned to it, the operating light's composite mode is switched
on. This feature is configurable; contact your Planmeca dealer.
To start the polymerisation cycle, first select the desired curing mode by
pressing the navigation button on the handpiece. Then, start the
polymerisation cycle by pressing the start button on the handpiece.
The polymerisation cycle can be interrupted by pressing the start button
again.
To start the polymerisation cycle with the foot control, first select the desired
curing mode by pressing the navigation button on the handpiece. Then, push
the foot control pedal to the right or to the left or down to start the
polymerisation cycle.
The polymerisation cycle can be interrupted by pushing the foot control
pedal to the right or to the left or down.
The length of the cycle is programmable, see section "Planmeca Lumion
Plus polymerisation light" on page 100.
When the polymerisation light is activated, the length of the polymerisation
cycle is displayed on the control panel. When you start the cycle, you will
hear a signal tone. This signal tone is repeated every 10 seconds, and also
at 5 seconds. The progress of the polymerisation cycle is displayed on the
control panel.
20 Operating instruments
User's manual Planmeca Compact i 87