Planmeca Compact i Classic v2, User Manual

Page: 119 / 190

Hanging-tube instruments: Start the flushing cycle by pressing
Instrument spray (you will hear a signal tone) and holding it for 3
seconds. Release the button when you hear a second signal tone.
The system will first identify the instruments and then each instrument
hose is flushed with air and water for 30 seconds in its turn.
5. Once the flushing cycle is finished, H 36 is displayed. Remove the
instruments from the flushing holder and return them to the instrument
console. Place the flushing holder cover back to its position.
If water flow was not detected for all water consuming instruments,
H 36.1 is displayed. Run instruments for a while with spray water to
ensure that the flushing of instruments is sufficient.
Press Instrument spray to view the instrument flushing results on the
display. The bars on the display represent the instruments in the order
they are placed in the instrument console. A full bar means that the
instrument was flushed successfully and a half bar that the flushing for
that instrument failed.
23.4 Long instrument flushing
About this task
NOTE
The duration of the long flushing cycle is configurable. Contact your
Planmeca dealer.
NOTE
You can flush the instrument hoses independently or at the same time as
you clean the suction system by using OroCup.
NOTE
You can interrupt the flushing cycle by pressing Instrument spray. After the
interruption, the dental unit can be used normally.
Steps
1. Remove the cup from the cup holder. Turn the bowl away from above
the flushing holder as shown in the figure. Turn also the cup fill tube
23 Flushing and cleaning programs
User's manual Planmeca Compact i 111