Planar m52L, Installation Manual

Page: 45 / 124

Adjusting Levels for Analog Sources
m52L Installation Guide 35
Manual Level Adjustment
1 Select a source in the
PICTURE
menu.
2 To access the
INPUT LEVELS
menu, press
LEVEL
on the remote.
3 Display an all-black picture from the source computer.
Note: Black Level must be done before White Level.
4 In the
INPUT LEVELS
menu, select
BLACK LEVEL
(
OFFSET
) and adjust it up and
down with the + or - keys to make the three
CENTER POINT
values go to zero.
Once any value reaches zero, use the individual colors under
BLACK LEVEL
to
adjust the other two values to zero.
5 Display an all-white picture from the source computer.
6 Adjust
WHITE LEVEL
(
GAIN
) until the
CENTER POINT
values go to 255. Once any
value reaches 255, use the individual colors under
WHITE LEVEL
to adjust the
other two values to 255 (or 254).
7 Although it is not required, we recommend that you save the configuration to a
memory slot. (See "Saving Configurations" on page 86)
8 If you have more than one source coming through the same connector, adjust
Input Levels for each source.
I n p u t L e v e l s
A u t o B l a c k L e v e l ( o f f s e t )
A u t o W h i t e L e v e l ( g a i n )
C e n t e r P o i n t 6 4 1 2 4 9 9
B l a c k L e v e l ( o f f s e t ) - A l l 7 9
R e d 8 9
G r e e n 6 7
B l u e 8 3
W h i t e L e v e l ( g a i n ) - A l l 9 9
R e d 9 9
G r e e n 9 9
B l u e 9 9