Phytec phyCORE-LPC2292/94, Hardware Manual

Page: 9 / 144

Contents
©
PHYTEC Messtechnik GmbH 2006 L-658e_5
Table 34: J800, J801 ETM/OCDS Connector Configuration
(DCM-023 only) ...................................................................... 45
Table 35: C210 CLKIN Configuration ................................................... 46
Table 36: System Startup Configuration – Boot Device Selection.......... 47
Table 37: System Startup Configuration – Debug/Trace Port ................. 48
Table 38: /CS Signal (Bank) Address Ranges and
Configuration Registers ........................................................... 50
Table 39: Memory Device Options for U607 .......................................... 57
Table 40: Memory Area Ethernet Controller ........................................... 60
Table 41: JTAG and TRACE Modes ....................................................... 67
Table 42: debugCORE-LPC2292/94 DIP Switch S800 .......................... 70
Table 43: ETM/OCDS Connector at X800.............................................. 71
Table 44: LAN MII Connector at X500................................................... 72
Table 45: Improper Jumper Setting for JP30/33 on the Carrier Board .... 83
Table 46: JP9, JP16 Configuration of the Main Supply
Voltages VCC / VCC2 ............................................................. 84
Table 47: JP9, JP16 Improper Jumper Settings for the Main
Supply Voltages ....................................................................... 85
Table 48: JP28 Configuration of the Boot Button ................................... 86
Table 49: JP28 Configuration of a Permanent ISP Mode Start .............. 87
Table 50: JP41 phyCROE-LPC2292/94 Boot Memory
Configuration ........................................................................... 88
Table 51: Jumper Configuration for the First RS-232 Interface .............. 89
Table 52: Improper Jumper Settings for DB-9 Socket P1A as
First RS-232 ............................................................................. 90
Table 53: JP24 Power Supply to External Devices Connected to
P1A on the Carrier Board......................................................... 92
Table 54: Jumper Configuration of the DB-9 Socket P1B
(Second RS-232) ...................................................................... 93
Table 55: Improper Jumper Settings for DB-9 Socket P1B
(Second RS-232) ...................................................................... 94