Phytec phyCORE-LPC2292/94, Hardware Manual

Page: 133 / 144

Ethernet Port
©
PHYTEC Messtechnik GmbH 2006 L-658e_5
121
17 Ethernet Port
The phyCORE Carrier Board HD200 provides a 10-pin header
connector at X7 for mounting the PHYTEC Ethernet transformer
module. The optional add-on module is available through PHYTEC
(order code EAD-003). This allows for direct connection of the
phyCORE-LPC2292/94 with populated Ethernet controller mounted
on a Carrier Board HD200 to a 10/100Base-T network
1
.
Figure 34: Ethernet Transformer Module Connector
The pinout for the Ethernet transformer connector is shown below:
Pin# Function Note
1 ETH_LanLED Make sure JP37 on the Carrier Board is closed at
position 1+2.
2 ETH_LinkLED Make sure JP38 on the Carrier Board is closed at
position 1+2.
3 VCC
4
5 ETH_TxD-
6 GND
7
8 ETH_RxD-
9 GND
10 VCC
Table 78: Ethernet Transformer Connector Pinout
1
: Note : New PCM-997-V3 PCB revision 1179.6 supports 100 Mbit/s Ethernet transmission.
1