Phytec phyCORE-LPC2292/94, Hardware Manual

Page: 99 / 144

The phyCORE-LPC2292/94 on the phyCORE Carrier Board
©
PHYTEC Messtechnik GmbH 2006 L-658e_5
87
2. The Boot input of the phyCORE-LPC2292/94 can also be perma-
nently connected to VCC via a pull-up resistor. This pulls port pin
P0.14 to low level via on-board circuitry which then starts the ISP
mode. This spares pushing the Boot button during a hardware reset
or power-on.
Caution:
In this configuration a regular reset, hence normal start of your
application, is not possible. The microcontroller will always enter ISP
mode after reset.
Jumper Setting Description
JP28 4 + 6 Boot input connected permanently with VCC via pull-
up resistor. The ISP command handler is always started
with reset or with connection of the power supply
Table 49: JP28 Configuration of a Permanent ISP Mode Start