PerkinElmer PINAACLE 900 Series, Customer Hardware And Service Manual

Page: 181 / 390

Preparing the System
5
Switching on the System
1. Read the safety information at the front of this guide before you operate the
system.
2. Make sure that the spectrometer system and other ancillary instruments are
correctly installed and connected to their power supplies. Make sure that the
coolant hoses are connected correctly to the spectrometer. Where applicable,
make sure that the cooling system is filled to the Max mark (see
Filling the
Cooling System on page 127 ).
3. Switch on the fume ventilation system for the work area.
4. Turn on the burner gases and adjust the outlet gauge pressures to the
recommended values. See Table 5-1 Required Pressures for the Burner Gases
on page 167 .
5. Turn on the inert (and special) gas for the furnace and adjust the outlet gauge
pressures to the recommended values. See Table 5-2 Required Pressures for
the Furnace Gases on page 168 .
Note
You must always turn on the air supply since air pressure is required for
the internal pneumatic system. If you intend to work with only one
atomizer, you only need to additionally turn on the gas supplies for that
atomizer.