FL20-C Series
35
3.2.2
Installation conditions
Environment
conditions
Equipment
location
Prevent tangy caustic gases and flammable gases
Altitude
1000m or below (derate use if over 1000m)
Atmospheric
pressure
86kPa~106kPa
Operating
temperature
-15°C~40°C
（
no freezing
）
Storage
temperature
-20~80°C
Humidity
Below 90% (no water-bead coagulation)
Vibration
Strength
Below 0.5G
（
4.9m/s
2
）
,10~60Hz (Discontinuous)
IP rating
IP65
3.2.3
Precautions on installation
Item
Description
Anticorrosive
Clean the anticorrosive paint that coasts the end of motor shaft before
installation, and then proceed the rust-proof treatment.
Encoder
Use screw hole on the shaft end when installing pulley on the servo motor shaft
with key slot. To install pulley, insert the double-headed nail into screw hole
firstly, use cushion ring on the surface of coupling end, and use nut to lock in
the pulley gradually.
Install with the screw hole in shaft end for the servo motor shaft with key slot.
Use methods such as friction coupling for servo motor shaft without key slot.
To avoid bearings bear strong impact of load, use remover to assemble pulley.
Install protective cover or similar device on the rotation zone, such as pulley.
Alignment
Use coupler to align the servo motor shaft with the shaft of the equipment when
connecting to the machinery.
Orientation Servo motor can be installed either horizontally or vertically.
Handing oil
and water
When using in the location with water drops, the protection level of servo
motor needs to be confirmed firstly.
When using in the location that oil could drops into the shaft through position,
do not remove the oil seal of servo motor.
Precautions on using servo motor with oil seal
The oil surface must be under the oil seal lip.
Use oil seal in favorably lubricated condition.
When servo motor installed vertically, do not make oil seal lip deposit oil.
Cable stress
Make sure there are no bends or tension on cables, especially for the signal line,
which core is only 0.2mm or 0.3mm, do not make too tight when wiring.
