Operating the Drive
4-3
650S AC Drive
A typical alarm
Initial Start-up Routines
Note:
Refer to Chapter 5: “The Keypad” to familiarise yourself with the keypad’s indications, and how to use the keys and menu
structure.
WARNING!
Unpredictable motion, especially if motor parameters are incorrect.
Ensure no personnel are in the vicinity of the motor or any connected machinery.
Ensure that machinery connected to the motor will not be damaged by
unpredictable motion.
Ensure that the emergency stop circuits function correctly before running the motor
for the first time.
The drive can be started in either Remote Control or Local Control.
By default, the drive will start in Local Control.
These routines assume that the drive’s control terminals are wired as shown in the Control Wiring Connections in Chapter 3.
Connected in this way, a positive setpoint will rotate the motor in a clockwise direction when viewed down the shaft, looking
toward the motor.
Note:
If during the start-up routine the display shows either an alarm (indicated by the letter “A”) or a
flashing Warning message, refer to Chapter 7: “Trips and Fault Finding”.
!
IMPORTANT
On power-up
in Remote
Control, the
drive will
immediately
start running if
the RUN
signal is
!
IMPORTANT
When power
is applied to
the drive in
Remote
Control, it will
immediately
start running if
the RUN
signal is
active.
