Paradyne COMSPHERE
3610, Operator'S Manual

Page: 203 / 310

C-1 3610-A2-GB91-90 July 1999
Diagnostic Control Panel
Messages Reference
Overview C-1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DCP to Async Terminal Messages C-1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Command Messages Format C-1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Messages C-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Health and Status C-3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Dial Backup Messages C-11 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TDM/MCMP/Bridge Messages C-14 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Overview
This appendix describes the messages that may be
displayed on the 3610 Series DSU’s diagnostic control
panel (DCP) when the Async Terminal feature is in use,
while a command is executing, or when an error condition
prevents execution. The status, progress, or error
messages are described in this section. The messages
listed here do not include menus, data entry displays, or
specific test results.
Health and Status (H/S) branch messages are provided.
These include the Device (Devic) health and status,
Expanded (Expan) health and status, and Subnetwork
(Subn) health and status messages.
In addition, dial backup progress and error messages,
as well as time division multiplexer (TDM), multichannel
multipoint (MCMP), and digital bridge error messages are
included.
DCP to Async Terminal Messages
When the Async Terminal feature is in use, one of
three messages is displayed on the DCP. Table C-1
identifies and describes these messages.
Table C-1
DCP to Async Terminal Messages
Message Condition
User I/F – Idle The async terminal is
enabled; the DCP is locked.
User I/F – Activ The async terminal is enabled
and a session is started.
Term: Stndby
(appears under
the Term
submenu) The async terminal is enabled
but inactive, and DCP access
has been initiated and a valid
password entered at the DCP.
The async terminal is in
Standby mode.
If no key is pressed after
5 minutes, the DSU reverts to
User I/F – Idle.
Command Messages Format
The format of the messages is shown below.
F1
Command Name
Message
F2
F3
C