Paradyne COMSPHERE
3610, Operator'S Manual

Page: 91 / 310

DSU Operations
4-11 3610-A2-GB91-90 July 1999
Select the port you want to view using the F1 (
↑
) and
F2 (
↓
) keys, then press the F3 key to display (Displ) the
status of the DTE port. For this example, Port 3 was
selected.
Results
The following report displays the DTE interface states
for the local or remote DSU selected. This report shows
the activity at the DTE interface, and may be different
from the states displayed by the DSU’s LED indicators
which sometimes reflect the internal states of the interface
circuits. In this example, Port 1 was designated.
F1
Prt03 DTE Stats:
TXD RXD DSR
F2
F3
From the DCP, the DTE interface statuses are
displayed in sets. Use the key to scroll the next set of
lead statuses into view. Table 4-3 lists the DTE lead status
codes.
Table 4-3
DTE Lead Status Codes
Code Lead Status
ON/SPACE (above text line)
Off/MARK (below text line)
At least one transition between
Off/MARK and ON/SPACE has
been detected during the
monitoring window.
Circuit Quality Status
Circuit Quality (CircQ) status displays the level and
quality of the signal being received from the network by
the DBM. (This report is only available for a V.32 DBM.)
Refer to COMSPHERE 3600 Series Data Service
Units, Models 3610 and 3611 Dial Backup Module and
SNA Diagnostic Interface Options, Applications Guide for
Circuit Quality information.
Identity
Identity (ID) displays a report listing a DSU’s model
number, serial number, software/firmware version,
network address, DDS rate, DBM rate, and the DBM type
installed.
To access the DSU’s Identity report from the top-level
menu, make the following selections:
•
Local (F1), or Remot (F2) and Address
•
Stat
•
ID
Results
You can display the Identity report for a local or
remote device. The following is an example screen:
F1
Identity:
Model: 3610
F2 F3
Table 4-4 lists the Identity report information provided
about a DSU and its options. Press the key to display
additional information, one display at a time.