Paradyne COMSPHERE
3610, Operator'S Manual

Page: 130 / 310

COMSPHERE 3600 Series Data Service Units
6-2 July 1999 3610-A2-GB91-90
Usr1, Usr2, and Usr3 storage areas may be used to
maintain predetermined option sets for specified
DSU, Diagnostic (DSU, DBM, and General),
DBM, General, Backup, MUX Setup and Ports,
Port Speed, and LPDA configurations.
NOTE
The next three option sets, FacC,
FacT, and FacB are read-only
storage areas; changes cannot be
saved to these option sets.
•
The factory-loaded configuration options for a
control DSU are contained in this area (FacC).
•
The factory-loaded configuration options for a
tributary DSU are contained in this area (FacT).
•
The factory-loaded configuration options for a
central-site DSU equipped with a digital bridge are
contained in this area (FacB).
Using the DCP to Set
Configuration Options
To access the Options submenu from the top-level
menu, make the following selections:
•
Local (F1), or Remot (F2) and Address
•
Confg
•
Opts
When Opts is selected, the following appears:
F1
Load from:
Activ
Remt Usr1
F2 F3
Usr2 Usr3 FacC FacT FacB
The selections on this menu are sets or libraries of
configuration options stored in the DSU’s memory. Refer
to
Table 4-10 in Chapter 4 for a list of default
configuration option sets (Load from option selections)
and their source.