Chapter 2
Getting Started — Setting up
36 - ENGLISH
2) Adjust the orientation of the main unit.
f
Rotate the shaft holder and adjust the ball joint movable part to the direction to tilt the main unit, and adjust
the orientation of the main unit.
Ball joint fixing screw
Ball joint stopper
Ball joint movable part
Shaft holder
Pole
360°
360°
The shaft holder will rotate 360° when the ball
joint fixing screw is loosened.
Rotate the shaft holder and move the ball joint
movable part to the direction to tilt the main unit.
The ball joint will become free when the ball joint stopper is removed.
The main unit can be rotated 360° or the main unit can be tilted 90° at
the ball joint movable part.
Ball joint movable range:
Approximately 90°
Main unit
Shaft holder
Ball joint stopper
3) Tighten the ball joint fixing screw.
f
While supporting the main unit, securely tighten the ball joint fixing screw using the supplied Allen wrench
(opposite side size 3/16").
Attention
f
The main unit and the power supply unit are connected with cables, etc. Do not rotate or tilt the main unit more than necessary.
f
When adjusting the orientation of the main unit while connected to an external device via connection cable, please be careful not to damage
the connection cable.
f
Please store the ball joint stopper in an appropriate manner for future use.
f
Note that your hand may get caught in between the pole and the main unit when the pole joint fixing screw is loosened while holding the
pole section.
Note
f
After adjusted roughly, fine adjust the projection position while projecting.
