Panasonic LightPix AE20, User Manual

Page: 68 / 151

4.4.2 Setting Procedure and Modes
Inspection is performed following the steps below:
1 Set up devices.
Install the main unit, and connect to a power supply unit,
each unit and external devices.
Section 3
2 Turn the LightPixAE20 on.
Apply 24 V DC. ---
3
Configure the
LightPixAE20
(in CONFIGURATION mode)
Set up the LightPixAE20 system in CONFIGURATION
mode. Hardware settings of the unit, output method of
reading data, saving method of captured images and other
inspection conditions.
Page 62
4
Run a teaching
(In TEACHING mode)
In the TEACHING mode, register edge direction and
distance, at the same time, set the exposure time or range
for measuring area (inspection area), and area for setting
extraction color.
Page 64
5
Set judgement criteria
(In JUDGEMENT CRITERIA
SETTING mode)
In JUDGEMENT CRITERIA SETTING mode, set the
allowable limits of edge distance for teaching execution.
Page 68
6
Execute an inspection
(In RUN / RUNVIEW mode)
Press the TRIGGER button in RUN (RUN VIEW) mode. Page 69
There are mainly four modes available for the LightPixAE20. The settings that you can make vary depending
on the mode. To switch the modes, follow the instructions below.
61