Panasonic LightPix AE20, User Manual

Page: 76 / 151

4.4.6 Inspection Execution
The Ways of Inspection Execution
Internal trigger: ON Inspection is automatically performed by switching to RUN mode.
Internal trigger: OFF
After switching to RUN mode, input the TRIGGER signal to external devices or
press the TRIGGER button.
Inspection Judgement Results
Judgement results are output to the parallel ports of OUT1 to OUT3 as the table shown below
Judgement Results OUT3 OUT2 OUT1
OK
Edge was detected and the detected edge distance
is within the “base di/- allowable range.
OFF OFF ON
NG Except those above OFF OFF OFF
Checking the measured data
When executing an inspection in RUN mode, you can check the X- and Y- directional distance of the
detected edge.
Display
data
switch
or
Upper line: Product type number and type of data
Type of data: X/Y
•
X: X-directional distance of the detected edge
•
Y: Y-directional distance of the detected edge
Lower line: Data value
•
Detection edge distance: Four digits including the
numbers under the decimal point)
(The number of digits under the decimal point differs
depending on the type of unit.)
When the unit failed to detect an edge, the screen
display is as the figure on the right.
Data type in the edge direction saved by teaching and the
data are displayed.
Product
type
switch
The <3>, <4> and <5> buttons:
Changes the product types
Once you change the product
types, OUT1 to 3 are reset.
*Range of data
Type
Data
ANE2000 ANE2010 ANE2020 ANE2030*
X 0 to 2.00 0 to 10.00 0 to 30.00 0 to 80.00
Y 0 to1.60 0 to 8.00 0 to 25.00 0 to 70.00
*The view range changes within the range of 70 x 56 to 100 x 80 depending on the installation position of
ANE2030, but the position data are converted into mm based on the range of view 80 x 70. Therefore, if you
use the unit out of the view range 80 x 70, the position data differs from the actual size.
Input/Output Timing: Page 102
69