Panasonic LightPix AE20, User Manual

Page: 103 / 151

Item Description Applica-
tion
CAP.D: (0 ~ 160 ms) 1
ms
Capture Delay
Indicates the waiting time for the LightPixAE20 to capture the image
after the TRIGGER signal input
But, the READY signal is turned off without delay after the TRIGGER
signal is input, irrespective of the Capture Delay time.
Inspection time (READY signal OFF time) will become longer by the
amount of the Capture Delay time All
I.TRR: (ON / OFF)
Internal Trigger
To select whether or not to execute an inspection by receiving the signal
to from the external device
•
ON:
Automatic continuous inspections (no need to receive the
TRIGGER signal from the external device)
•
OFF:
Executes an inspection for each TRIGGER signal input from the
external device
All
INI.T: (1 ~ 7)
Initial Type
Product type No. that is called when turning on the LightPixAE20 All
SPEED: (High / Mid /
Low)
Speed
Select your desired inspection speed from the following three options.
You can speed up the LightPixAE20 by changing the speed in the
following order:
Low -> Middle -> High
Every time you change the speed, the “computation time” is also
changed. Speed for each application is as the table shown below:(Unit:
ms)
High Middle Low
Color Jdgement 20 50 150
Color Pattern 100 200 500
Edge Detection 10 15 20
Measurement 15 20 30
If you set Speed to Middle or High, the unit scans the 352 pixels
(horizontal) x 288 pixels (vertical) by skipping some of them. Therefore,
the inspection results differ depending on the setting value.
Refer to the pages describing the Color Pattern Matching.
Color
Judgement
/ Color
Pattern
Matching /
Edge /
Measurem
ent
T.TRG: (ON / OFF)
Teaching Trigger When the TRIGGER signal is input from the external device, you can
select whether or not execute a teaching.
•
ON: TRIGGER signal on
The LightPixAE20 executes a teaching after the TRIGGER signal
input TRIGGER
•
OFF: TRIGGER signal off
The LightPixAE20 executes a teaching only when the TRIGGER
button is pressed. It does not execute a teaching even when the
TRIGGER signal is input.
The setting of this function is effective only in TEACHING mode, not in
other modes.
All
96