Panasonic LightPix AE20, User Manual

Page: 79 / 151

4.5.2 Setting Procedure and Modes
Inspection is performed following the steps below:
1 Set up devices.
Install the main unit, and connect to a power supply unit,
each unit and external devices.
Section 3
2 Turn the LightPixAE20 on. Apply 24 V DC. -
3
Configure the
LightPixAE20
(in CONFIGURATION mode)
Set up the LightPixAE20 system in CONFIGURATION
mode. Hardware settings of the unit, output method of
reading data, saving method of captured images and other
inspection conditions.
Page 73
4
Run a teaching
(In TEACHING mode)
In the TEACHING mode, register a distance between the left
upper of the point in the inspection area and the detected
point, set the exposure time or range for measuring area
(inspection area), and area for setting extraction color.
Page 75
5
Set judgement criteria
(In JUDGEMENT CRITERIA
SETTING)
In JUDGEMENT CRITERIA SETTING mode, set the
allowable distance limit between the left upper inspection
area of the point and the point.
Page 79
6
Execute an inspection
(In RUN / RUNVIEW mode)
Press the TRIGGER button in RUN (RUN VIEW) mode. Page 80
There are mainly four modes available for the LightPixAE20. The settings that you can make vary depending
on the mode. To switch the modes, follow the instructions below.
72