Chapter 6
Appendix — Installing optional accessories
ENGLISH - 71
Installing optional accessories
Make sure to ask a qualified technician or your dealer to install optional accessories.
r
To the equipment installer:
Before you begin, make sure to read “Read this first!” (
x
page 2), “Setting up” (
x
page 22).
Precautions for installing and removing optional accessories
f
Make sure to turn off the power before installing or removing the interface board or POWER SUPPLY.
f
When switching off the device, make sure to follow the procedures in “Switching off the device” (
x
page 37).
f
Do not touch the connecting part of the POWER SUPPLY and interface board directly.
g
Doing so may result in static electricity that damages components.
f
To prevent damage by static electricity, touch a metal object nearby to remove electrostatic charge on your body before you begin.
f
Be careful to avoid injury when installing or removing optional accessories.
g
If touched by mistake, lead lines of parts, traces of soldering, and other sharp areas on the surface of the interface board may cause
injury to the hand.
g
If touched by mistake, empty slot openings on the device and edges of the interface board brackets may cause injury to the hand.
f
Install the optional interface board or the POWER SUPPLY to the device by slowly and securely inserting it horizontally into the connector.
g
Incorrect attachment may result in failure to operate or malfunction.
Restrictions on interface board attachment slots
This device has 16 slots to connect input and output interface boards, with the following slot restrictions:
f
Slot1
and
Slot2
are only for input interface boards. Output interface boards cannot be installed.
f
Slot15
and
Slot16
are only for output interface boards. Input interface boards cannot be installed.
f
Install input interface boards in ascending order starting at
Slot1
without leaving any slots empty. To use the device, you will need to attach
at least one input interface board to
Slot1
.
f
Install output interface boards in descending order starting at
Slot16
without leaving any slots empty. To use the device, you will need to
attach at least one output interface board to
Slot16
.
f
An empty slot can only be set to remaining slots between an attached slot on an input interface board and an attached slot on an output
interface board.
f
Make sure to attach a slot cover to empty slots.
Slot1
Slot5
Slot9
Slot13
Slot2
Slot6
Slot10
Slot14
Slot3
Slot7
Slot11
Slot15
Slot4
Slot8
Slot12
Slot16
Only for input
Only for output
Slot order for installing the input interface boards
Slot order for installing the output interface board
Installing the interface board
Screws
Screws
Fig. 1
Fig. 2
Fig. 3
1) Remove the slot cover. (Fig. 1)
f
Use a Phillips-head screwdriver to turn the two screws with toothed lock washers securing the slot cover counterclockwise and
remove. The removed screws with toothed lock washers will be used to secure the interface board.
