Chapter 1
Preparation — About your device
20 - ENGLISH
r
Interface Board for Digital Link 2output (Model No.: ET-MCQDL350)
DIGITAL
LINK
DIGITAL
LINK
1
1
2
3
4
6
5
5
1 <DIGITAL LINK> terminal
Connects to a DIGITAL LINK-compatible display (projector or
flat panel display) or a Panasonic-recommended twisted-pair-
cable transmitter (receiver) using a CAT5e cable or higher
(
x
page 29).
2 <LAN> terminal
This terminal is used for connecting to the network.
Using a computer on the network, you can monitor and control
a display (projector or flat panel display) connected to the
device through DIGITAL LINK.
3 LAN10/100 indicator
Turns on when connected to the 100Base-TX.
4 LAN LINK/ACT indicator
Turns on when connected and flashes when sending and
receiving signals.
5 DIGITAL LINK indicator
Displays the status of the link with an external device.
Green: Connected to an external device via a cable.
Orange: An HDCP signal is being input.
Orange flashing: A non-HDCP signal is being input.
6 Status indicator of the interface board (
x
page 20)
r
POWER SUPPLY (Model No.: ET-RPS100G)
POWER
OFF ON
AC IN~
100-240Vac
50-60Hz
+12V
1
3 4
2
1 <POWER> switch
Turns the power on/off.
2 <AC IN> terminal
This terminal is used for connecting the supplied power cord.
3 Power input indicator
Displays the power input status.
Turned on at all times while the device is on and turns off when
the power is switched off.
4 Power output indicator
Displays the power output status.
Turns on when DC voltage is output.
Status indicator of the interface board
Displays the status of the interface board.
Indicator status
Interface board status
Green
On
In operation.
Red
On
Preparing.
Off
Power is off or an error has occured.
Note
f
If the status indicator of the interface board does not light in green even a few seconds after switching on the device, ask your dealer to
inspect or repair the device.
