Chapter 6
Appendix — Specifications
ENGLISH - 69
Compatible signal
Signal name
Resolution
(Dots)
Scanning freq.
Dot clock freq.
(MHz)
Compatible signal
format
*3
Horizontal
(kHz)
Vertical
(Hz)
D
R
Y
WUXGA
*5
1920 x 1200p60cvt-
rb
1 920 x 1 200
74.0
60.0
154.0
l
l
―
*1 DVI 1.0 compliant, HDCP compatible
*2 Includes DIGITAL LINK output.
*3 A signal, which has
l
in the compatible signal format column, is compatible with each format.
*4 If the input is a digital signal protected with HDCP, it can not be output.
*5 VESA CVT-RB (Reduced Blanking)-compliant
Note
f
The “i” at the end of the resolution indicates an interlaced signal.
f
When interlaced signals are connected, flickering may occur on the projected image.
f
The compatibility status above applies only when interface boards compatible with each signal format are attached to the device.
f
Some signal formats require a conversion adaptor for connection with an external device.
f
When using the device with the following screen configurations while connecting to the projector PT-RZ470 series/PT-RW430 series/
PT-RZ370 series/PT-RW330 series/PT-RZ475 series, noise might occur at the boundaries of layout if the output signal is set to interlaced
signal.
g
When input source does not fit in one layout and overflows
g
When input source crosses over multiple layouts
In these cases, select something other than interlaced signal in [Outputs]
→
[Resolutions] on the [Settings] page of the control software.
