OPTIMUM
M A S C H I N E N - G E R M A N Y
Assembly and commissioning
Version 1.1.6 dated 2014-10-16
Page 33
Original operating instructions
F150
GB
Fix the load suspension gear (e.g. lifting slings) on the four ring bolts of the machine sub-
structure and of the column.
"Total weight [kg]“ on page 21.
WARNING!
There must be no inclined traction due to the load suspension gear.
Img.3-3: “Transporting by crane“ on page 32
3.8
Installation and assembly
Position the machine feet included in the delivery volume below the adjusting screws of the
machine substructure.
Align the CNC machine with a machine spirit level.
Img.3-6: Machine feet
3.8.1 Aligning the machine
Align the CNC machine on the machine bed by means of a machine spirit level. Use the set
screws in order to perform the required height levelling.
The slope deviation of all levels must not exceed 0.03/1000mm.
ATTENTION!
An insufficient rigidity of the substructure leads to superposition of vibrations between
the multifunctional CNC machine and the substructure (natural frequency of the
components). Critical speeds and moves in the axis with displeasing vibrations are
rapidly achieved in case of insufficient rigidity of the whole system and will lead to bad
milling results.
Check the correct alignment of the machine after a few days of usage.
Fix by means of adjusting screws.
Adjusting screw
Counter nut
Machine foot
